Polestar Evaluates Strength of Carbon Fibre in Successful First Crash Test
|Author: Barbara Sadowy, November 12, 2018|
Date: Wednesday, November 28th, 2018
Polestar has undertaken the first of a series of crash tests as part of the development of the Polestar 1. This represents the first time the Volvo Car Group has assessed the strength of a carbon fibre reinforced polymer body in a real crash situation.
“We were really excited about this crash test. The first crash test of Polestar 1 has been about exploring the unknown,” says Thomas Ingenlath, Chief Executive Officer at Polestar. “This was a crucial proof point in the development of Polestar 1; we had to know that the ideas and calculations that have gone into building this car were right – and they were.”
In contrast to a steel body where bending helps the integrated crumple zones to reduce the amount of crash energy that reaches the vehicle’s occupants, carbon fibre dissipates energy by cracking and shattering.
Close attention was given to the way the carbon fibre body reacted to the extreme forces involved in the impact. The engineers also focused on how the underlying steel body structure, and carbon fibre ‘dragonfly’ which strengthens it, managed the forces.
The Polestar 1 verification prototype, part of the first Polestar 1 build series, was propelled into a stationary barrier at 56 km/h, simulating a frontal collision.
Most of the energy was absorbed by the car’s crash structure, with the remaining energy mitigated by the carbon fibre body panels into the body structure which remained rigid and did not show signs of bending or misalignment after the crash.
Zef van der Putten, responsible for carbon fibre at Polestar, comments: “The outcome of this first crash test validates the decision to build the body of Polestar 1 in carbon fibre. It also confirms that carbon fibre supports the highest safety standards. This is an example of how Polestar spearheads the development of new technology in the Volvo Car Group.”
The crash test was conducted at the Volvo Cars Safety Centre in Gothenburg, Sweden, where cars and other vehicles are crash-tested in many real-world simulations.
While it's not news to manufacturing companies that workers, of any collar, are hard to find, a new report from the Conference Board found that it is harder to find blue-collar workers than white-collar workers...
Scientists at the Department of Energy’s Oak Ridge National Laboratory have created a recipe for a renewable 3D printing feedstock that could spur a profitable new use for an intractable biorefinery byproduct: lignin...
(IW – Staff: 11-16-18) Despite the widespread fear, and more than enough reports, proclaiming that robots will be taking over the factory floor, it seems that time has not yet come. Humans still perform 72% of manufacturing tasks...
No Featured Articles for this category
Note: documents in Portable Document Format (PDF) require Adobe Acrobat Reader 5.0 or higher to view,
download Adobe Acrobat Reader.
Note: documents in Excel format (XLS) require Microsoft Viewer,
Note: documents in Word format (DOC) require Microsoft Viewer,
Note: documents in Powerpoint format (PPT) require Microsoft Viewer,
Note: documents in Quicktime Movie format [MOV] require Apple Quicktime,